Which ever you choose the packages have instructions.īe carefull, pots act like big heat sinks and melt very easy.ĭouble check that diagram and I bet you'll see what I'm talking about. There's two ways to do this, with a desoldering iron or use a desoldering braid. To solve this you need to desolder the lugs on each potentiometer. Gibons grounds to the can, so you have two volume controls per pickup. If you look at that diagram you'll see the number three lug on the tone pots aren't grounded to the can. You can twist and solder the red and white wires together the tape or heat shrink tubing.ĭuncan's north start/finish and south start/finish wires are completely different than Gibson's. I also wired SDs into my Gibson LP Deluxe but it was much easier and also a couple of years ago, so I don't remember exactly what I did nonetheless, I've been gigging happily with it ever since. Since everything on the Epi had to go in and out through the treble f-hole, I had to be extra careful, but the results are well worth it (Seymour Duncan Jazz neck humbucker and JB bridge pickups). Patience is rewarded, making sure all contacts are well soldered: use a multimeter to ensure that all grounds, especially, are robust. I followed the Stewart0McDonald and Seymour-Duncan wiring diagrams. White was soldered to the pot back (it helps to roughen up the surface with a file so the solder will stick) and the black to the center tab on the pot. I did the same to the green and bare wires (both go to ground) and soldered a white"tail" to the resulting single lead so the wire would be long enough, and added another tail to the black wire. On my Epiphone Sheraton II, I twisted the red and white together, then put a coat of solder over the joint, and sealed it with a piece of heat shrink tubing. It sounds as though yu have some connections touching. When you solder the red and white together, you are in effect bypassing the coil tap facility. Any help would be greatly appreciated as I am severely bumed out with the tone of my beloved Paul, and somewhat regreting taking out the stock pickups. The diagram just says to tape them together and nowhere in the numbered instructions tells me to actually connect the Red and White wire. I was wondering if I should twist and solder THEN tape the Red and White wires together. Also the tone knobs seem to be controlling my volume, even though I did not touch or interfere with any of the tone pots or any other wires I drew a diagram and the wires are all still connected. lol) I have to turn my amp up louder than with stock pickups and the tone has no bottom end. Ive searched various forums, pickup websites, google. Has anyone got one they could share or know of an online resource where I can find it or point me to it. Ive been searching for days for a wiring diagram for 2 humbuckers wired 2 a 3 way strat type blade switch and no tone pot. I did this and the guitar sounds horrible, it almost sounds like a strat(no offense to Strat users. Wiring Diagram - 2HH, 1 Volume, 3 way blade switch, no tone. In the diagram it says to tape the Red and White wires together. Now I am a little confused on what to do with the Red and White wires of each pickup. I did the same for the Neck pickup (wiring them to the upper right Pot). I soldered the Black wire to the lefthand tab of that same Pot. I soldered the Green and Bare wires of the bridge pickup to the back of the upper left Pot. I (hope) I am not done with wiring the new Seymour Duncan pickups in my Gibson les Paul.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |